Hardwood Flooring Installation in Garland, TX

Usually it is an advantage. The pre-1950 stock around the downtown square and Travis College Hill sits over a crawlspace with plank subfloor, so squeaks, soft spots, and sag can be fixed from below instead of by tearing out the room. Original oak strip is often thick enough to sand and refinish, and where the planks are rough we overlay plywood and lay new goods on a flat, sound deck.

Worth checking, not worth panicking over. Most of Garland was built between the 1950s and the 1980s, and nine-inch resilient tile with black cutback mastic from before the late 1970s often contains asbestos. We test rather than assume, and we never sand, grind, or dry-scrape suspect material. Intact tile can frequently stay put and be covered with a floating floor, which is cheaper and safer than removal.

Because they are effectively two different jobs. The post-2005 homes near Firewheel Town Center are open-plan on a young post-tension slab with builder porcelain and carpet. The Duck Creek and Embree streets are 1950s and 1960s, smaller rooms, early slab or pier-and-beam, and often layered old flooring underneath. Same city, thirty to fifty years apart, and the prep is where the difference lands.

It rules out anything that needs a fastener driven into the concrete, because the steel cables inside are under load and cutting one is a serious repair. On a wood floor that costs you nothing. Engineered plank is either bonded to the surface with a urethane adhesive or floated over a pad, and neither method touches the inside of the slab.

Yes, and it is common here. Wood handles a dropped glass and a wiped-up spill without complaint. What it does not handle is standing water under a dishwasher, or an ice maker line that weeps for a month before anyone notices. Use engineered rather than solid, seal the run where the floor meets the cabinets, and keep full bathrooms on another material.

Baseboards usually stay put. We install to the wall and finish with shoe molding, which is cleaner than pulling trim that was caulked and painted in place. Door casings get undercut so the plank slides beneath them rather than being scribed around them, and if the new floor sits higher, interior doors get trimmed at the bottom.